Eutonomy - Adaptater euFIX DIN for Fibaro FGR-222 (with push-buttons)

The euFIX R222 adapter is used to install the module Fibaro® Switch FGR-222 on a rail of type DIN TH35 in an electrical cabinet.

It is composed of a box as well as a circuit board to which the FGR-222 is attached. Its dimensions are adapted for a mounting on a standard rail of type DIN TH35/TS35.

The circuit board contains a set of screw terminals, to which all the wires (power supply, input and output signals, control buttons) can be connected with complete safety.

The front panel of the box contains two micro switch diagnostic buttons S1 and S2, which can be used to control the module, connect it to or disconnect it from the Z-Wave system without opening the box of the adapter.

The Fibaro module is not included and must be bought separately.

Functions

• Adapter used to install the module Fibaro Switch FGR-222 on a rail of type DIN TH35 / TS 35 in an electrical cabinet
• Free slot with label to identify the controlled line
• Micro switch push buttons S1 and S2 used to control, include or exclude the module in the Z-Wave system

Technical specifications

• Supply voltage: 230 V AC +/- 10%, 50-60Hz
• Load power: max. 8A
• Dimensions: 34.8 x 87.3 x 64.7 mm
• Width in TE units: 2 TE modules
• Conducting wire section: max. 2.5 mm2
• Maximum length of connected wires at inputs Sx, S1, S2: 20m
• Operational temperature: 0° C to + 50° C
• Relative humidity: ≤90%, no condensation
• Directives:
  • LVD 2014/35 / CE
  • RoHS 2011/65 / UE