Presentation
The EnOcean TRIO2SYS occupancy sensor detects the presence of (movement) of people.
Autonomous, the energy it needs is produced by a solar cell that operates without requiring any maintenance. An internal charger stores energy to ensure full operating capacity even after several days of total darkness.
It is particularly suitable for electrical installations without embedded wiring, such as: renovations, service system modifications or modular offices.
The detector has a constantly-active PIR sensor. If movement is detected, a radio telegram indicating a “busy” state is immediately transmitted; a 2 minute delay is then triggered (no telegram will be sent before the expiry of this period).
The detector can then react in 2 different ways:
a) Occupancy has been detected, the unit transmits a telegram. A new time period is set.
b) No occupancy is detected, the device transmits two messages to report that it is idle: the first after 10 minutes and the second 30 minutes after the last transmission that indicated a movement. If the device detects motion during this state, a movement alert is sent immediately.
Delivered complete and ready to mount
Technical Data
- Power supply: Solar powered (with optional extra CR2032 battery)
- In's/Outs
- Solar cell for energy recovery
- PIR sensor with 360° lens
- 2 buttons with LEDs for device configuration
- Sensor range: 12m diameter
- Radio frequency: 868.3MHz
- Range within buildings:
- Masonry: 20m, through 3 walls maximum
- Reinforced concrete: 10m through 1 wall/ceiling maximum
- Drywall/Timber: 30m, through 5 walls maximum
- Light required to maintain operation:
- 15 lux for 6 transmissions/hour
- 50 lux for 30 transmissions/hour
- 100 lux for 60 transmissions/hour
- Charging time to start
- 1 minute at 15 lux
- 5 seconds at 200 lux
- Time to fully charge
- 3 hours at 200 lux (after the start)
- 6 hours at 200 lux (cold start)
- Lifetime in complete darkness after a full charge: 48 hours
- Battery autonomy in total darkness: 5 years
- Dimensions: 160mm x 60mm x 37mm
- Operational environment: -10°C to +40°C
- Weight: 125g
- Installation height: 2 to 3m
- Use
- Motion/Presence Detectors
- Type
- Sensor
- Function
- Motion detection (PIR)
- Gateway compatibility
- eedomus+ - compatible via optional adapter
- Protocol
- EnOcean