FIBARO - Z-Wave+ FGD-212 dimmer module (FIBARO Dimmer 2)

Fibaro dimmer micromodule

The FGD-212 dimmer micromodule will give you remote control over a table, standard or ceiling lamp, thanks to the Z-Wave protocol, while maintaining your existing switch.

You can therefore switch the connected lamp on or off and vary its intensity using the existing switch, a Z-Wave transmitter or directly via the button on this micromodule.

The new Fibaro FGD-212 dimmer is equipped with an intelligent light source detection algorithm that facilitates configuration and ensures the high compatibility of the device. 

It has a self-protection function against overloading and a soft start function.

In the case of non-dimmable light sources, only an ON/OFF function is possible (3 wire connection).

It is compatible with any type of lamp whether dimmable or not:

• As a dimmer
  • Conventional light sources, both incandescent and halogen, with a 230V AC power supply
  • 12V halogen lamps (with electronic transformers)
  • 12V halogen lamps (with ferromagnetic transformers)
  • Dimmable LED lamps
  • Dimmable compact fluorescent lamps (CFL)
  • Using the Bypass, with a dimmable light source up to 225VA with a 2 wire connection (depending on load type)

• As a switch
  • Fluorescent lamps
  • LED lamps
  • Using the Bypass, with any compatible light source up to 225VA (according to the load type)

It can be used in 2 wire mode (no neutral), to replace an existing switch, or three wires with a conventional power module (live + neutral). 

For lamps with very low power consumption (LED lamp, for example), you can use the FGB-001 load (bypass) that enables the module to function correctly.

In addition to the dimmer function, this micromodule can also measure the power consumption of the connected device. Instant consumption (in W) and total electricity consumption (in kWh) can be consulted.

Each Z-Wave module functions as a wireless repeater with the other modules to ensure that your home is fully covered.

Features

• Remote control for lighting
• Fits behind an existing switch
• ON/OFF and Dimmer functions
• Use in 2 wire mode (neutral not required)
• Integrates a 500 series Z-Wave chip
• Communication 250% faster compared to standard Z-Wave devices 
• Automatic load detection
• Protected against overload
• Compatible with Z-Wave and Z-Wave+ controllers
• Active power and energy measurement function
• Works with different types of switches - push-button, rocker, three-way, etc.
• Soft start function
• LED diode indicating inclusion and calibration status, MENU levels
• Integrated Z-Wave range tester
• Automatically detects wiring faults, high temperatures, blown light bulbs, power surges and overloads
• Advanced setting options
• Small, discreet and aesthetic
• Ease of use and installation

Technical specifications

• Type of module: Z-Wave receiver
• Power supply: 230V +/10%, 50Hz
• Consumption: 1.3W
• Wiring: neutral not required
• Maximum load 50-250W (resistive load) or 0.25-1.1A (inductive load)
• Compatible lamp type (dimmable) Incandescent, CFL, Halogen (230V AC and 12V DC with electronic transformer), LED
• Compatible lamp type (non-dimmable) CFL, LED
• Frequency: 868.42 MHz
• Signal strength 1mW
• Transmission distance: 50m free field, 30m indoor
• Dimensions: 42.5 x 38.25 x 20.3mm
• Operating temperature: 0-35°C
• Maximum temperature: 105°C
• Standards: RoHS 2011/65/EU, LVD 2006/95/EC, EMC 2004/108/EC, R&TTE 1999/5/EC