FIBARO ROLLER SHUTTER 4 is a device designed to control blinds, awnings, venetian blinds, curtains, and pergolas. FIBARO ROLLER SHUTTER 4 allows precise positioning of blinds or venetian blind slats. The device is equipped with energy monitoring. It allows controlling connected devices either via the Z-Wave network or via a switch directly connected to it.
New Design
FIBARO focused on easy installation and intuitive first use. There are more entries for N and L wires, allowing the use of junction connectors (Wago terminals) to be abandoned.
Smaller Device
The shape and dimensions of the device allow easy and quick installation in recessed boxes. The button and diode are easily accessible.
Equipped with Plug-in Connectors
Allows for even faster assembly - no need to use a screwdriver.
3 Additional Connection Cables Included in the Box
Additional wires for connecting the switch are included.
Built-in Bridge
Easy bridging option for power and neutral. It is not necessary to use Wago connectors to connect the wires. You save space in the box and shorten installation time thanks to the push connector.
Features of the Fibaro Roller Shutter 4
- Compatible with any Z-Wave or Z-Wave+ controller
- One of the smallest shutter controllers available
- Equipped with the Z-Wave 800 chip for better range
- Supports Z-Wave network security modes: S0 with AES-128 encryption and S2 Authenticated with PRNG-based encryption
- Can be used with blinds, venetian blinds, pergolas, curtains, awnings, blind motors with electronic or mechanical limit switches
- Active power and energy measurement functionality
- Works as a Z-Wave signal repeater (all non-battery powered devices in the network will act as repeaters to increase network reliability)
- Works with various types of switches: momentary, toggle, and dedicated roller blind switches
- Easy and quick installation thanks to the push connector and built-in bridge
- To be installed in wall switch boxes
Technical Specifications of FIBARO FGR-224
- Power supply: 100-240V~50/60Hz
- Rated current: 2A for motors with compensated power factor (inductive loads)
- Supported motor type: single-phase AC motors
- Required limit switches: electronic or mechanical
- Operating temperature: 0°C - 35°C
- For installation in boxes: Ø = 50mm, depth ≥ 60mm
- Radio protocol: Z-Wave (800 series chip)
- Radio signal power: up to 5dBm
- Radio frequency band: 868.4 MHz
- Range: up to 100m outdoors, up to 30m indoors (depending on terrain and building structure)
- Dimensions (L x W x H): 46mm x 36mm x 19.9mm
- EU directives compliance: RoHS 2011/65/EU, RED 2014/53/EU
