Heatit controls - Thermostat Z-Wave Heatit Z-TRM3fx 3600W 16A, White

PRESENTATION

Heatit Z-TRM3fx is an electronic thermostat for electrical floor heating. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Futurehome, Smarthings, Homeseer, Vera, Zipato etc.

Heatit Z-TRM3fx is equipped with a single pole switch and it fits most System 55 frames (Elko RS16, Schneider Exxact, Gira, Jung etc.). The thermostat can withstand a load of max 16A /3600W at 230V. At higher loads the thermostat must control a contactor. The thermostat may be connected to two wired external sensors.

The thermostat has the capacity of up to 5 associations (relays, wall plugs etc.).

The thermostat is designed for electrical heating. It can also be used for waterborne floor heating when linked with Heatit Z-Water.

FUNCTIONS

• Floor sensor
• Indoor sensor
• External room sensor
• Temperature limiter
• Weekly program/setback via gateway or pilot wire
• Power metering
• Can be used in connection with different NTC-sensors
• Lock mode/child lock
• Calibration
• up to 5 associations

TECHNICAL CARACTERISTICS

• Z-Wave Plus
• Ratings voltage: 230V 50/60Hz
• Max load: 3600W (resistive load)
• 750W self-limiting heating cable
• Max current: 16A
• Power consumption: <2,0W
• Min/max operating temperature: 0°C – 40°C
• Temperature intervals Floor Sensor: 5°C – 40°C
• External Room Sensor: 5°C – 40°C
• Hysteresis 0,3°C – 3,0°C (default 0,5°C)
• Switchable Single-pole switch
• Compatible with NTC sensors with values 10, 12, 15, 22, 33 and 47 kΩ @ 25°C
• Included in package Floor Sensor