Qubino - Z-Wave+ Flush on/off thermostat ZMNKID1 (Qubino Flush ON/OFF Thermostat 2)

The Qubino On/Off 2 thermostat module is ideal for remotely controlling electric or water-based floor heating systems, electric water heaters, hot water pumps, electric heaters and the like. It is connected directly to a 240 V AC or 24 V DC power supply, no battery is needed.

Tracking the power consumption of your heating system

The smart thermostat measures the power consumption of the connected heating system - current consumption in W and cumulative consumption in kWh.

Measure and regulate temperature automatically

The Qubino Flush On/Off Thermostat 2 comes with a digital temperature sensor. It allows you to measure and regulate the room temperature by automatically switching the connected heater on or off.
 

Compatible with a large number of heating systems

The Flush On/Off Thermostat 2 works with water heaters, heat pumps, radiators, underfloor heating, radiant panels, etc.

Quick and trouble-free installation with Z-Wave SmartStart

The smart thermostat configuration is user-friendly for everyone. Just scan the QR code on the device, install it and power it up. Your SmartStart home automation box recognises the device and the inclusion is carried out automatically.

Protects your smart home from cyber attacks

The Qubino Flush On/Off Thermostat 2 is not only easy to configure, but it is virtually impossible to hack, with the highest security level of the market for smart home devices thanks to S2 authentication.

Functions

• Remote control (via smartphone or PC) and local activation/deactivation of valves for electric or water-based underfloor heating systems, electric water heaters, hot water pumps, electric radiators and the like
• Operates with a push button (momentary switch) and a rocker switch
• Able to measure the power consumption of the connected device in real time via a smartphone
• Operates on 110-240 VAC or 24-30 VDC
• Has one of the easiest and fastest installations of this type of equipment; even fits into smaller flush or junction boxes
• Saves and restores the last status after a power failure
• The range of the digital temperature sensor is -25 to + 80 ° C.
• Supports SmartStart inclusion for fast installation
• Automatically turns the device on/off according to the hysteresis.
• Automatically turns on the unit if the temperature is too low (antifreeze).
• Supports additional parameters for expert users, allowing advanced configuration
• Acts as a signal repeater that improves the range and stability of your Z-Wave network
• Can be used to remotely control and trigger other devices on your Z-Wave network

Technical Specifications

• Power supply: 110 - 240 VAC ± 10% 50 / 60Hz, (24-30VDC)
• Nominal load current of the AC / DC output (resistive load): 1 X 10 A (230 V CA) / 1 X 10 A / 30 V CC
• AC/DC output circuit power (resistive load): 2300W (230VAC) / 240W (24VDC)
• Precision of the power measurement: P = 5-50W, +/- 3W P> 50W, +/- 3%
• Operating temperature: -10 ~ + 40 ° C
• Z-Wave operating range: up to 40 m indoors
• Dimensions (WxHxD) (with packaging): 41.8x36.8x16.9mm (115x96x22mm)
• Weight (with packaging): 48 g (64 g)
• Electricity consumption: 0.4W
• For installation in boxes: Ø ≥ 60 mm or 2M
• Switching: relay
• Length of the digital temperature sensor cable: 1000 mm
• Z-Wave repeater: Yes