Presentation
The Water Sensor 7 is a sensor designed to detect drips and leaks and help mitigate water damage through the use of wireless coupled technologies such as water shut-off valves.
Battery powered and built on Gen7 and 700 Z-Wave technologies, the Water Sensor 7 has been designed as a set and forget product with up to 3 years of battery life.
Leak detection
Leaks are a recipe for costly bills and expensive damage when they appear where they shouldn't. Monitoring more than just the presence of liquid, the Aeotec Water Sensor 7 lives up to its name by monitoring the absence of water. When used to monitor tanks or pits, the Aeotec Water Sensor 7 can alert you when water levels get too low and trigger automation routines.
Leakage protection
It doesn't just monitor when the water goes bad. When connected to a Z-Wave automation system, the Water Sensor 7 can take protective measures to help limit the amount of damage caused by drips, leaks, splashes or other water flow.
Quality foundation
The accuracy, reliability and compatibility of the Water Sensor 7 starts at its foundation. With a leakage processor measuring only 70x30mm, it has been built on Aeotec's exclusive Gen7 technology, allowing it to be installed wirelessly almost anywhere in a room and run for 3 years before its single 3.6 volt battery needs changing.
Features
- Highly accurate 0.5mm leak detection via a sensing probe
- Ultra-compact form factor
- Sensor probe for leak detection in hard-to-reach areas
- Designed with Gen7 technologies and Z-Wave 700 series chip inside
- Gen7 enables compatibility with Security 2 and SmartStart
Technical characteristics
- Power: 1/2 AA ER14250 3.6V battery
- Battery life: up to 3 years
- Radio frequency: 868.42 MHz
- Operating distance: up to 150 meters outdoors, 50 meters indoors
- Operating humidity: 10 to 95%.
- Operating temperature: 0°C to 45°C
- Cable length: 1.5 m
- Dimensions: 70x13x20mm
- Weight: 42 g
