Secure - Z-wave+ Wall Thermostat with LCD display + Actutor

Introduction

Easily install a thermostat without running new wires and control it remotely via your Z-Wave home automation controller.

This package includes the Horstmann SRT321 thermostat and the SSR303 receiver. These two components offer a high-quality design, which allows you to install them wherever you like.

The thermostat

The SRT321 is a wireless, battery-operated wall thermostat. It is equipped with a rotary knob allowing the user to adjust the set point temperature in the room. By comparing the set point temperature with the real measured temperature, the thermostat decides whether or not to activate the wireless receiver connected to the heater.

The thermostat can also receive the set point temperature remotely, via your home automation controller. It can also be used as a temperature sensor. 

The receiver

The SSR303 actuator is a wireless relay that can switch loads of up to 3A/230W. It is used to control your electric heater, your water boiler or a magnetic valve. Very easy to use, this device can be controlled locally by two buttons. An LED indicates the current switching state.

Functions

• Wireless Z-Wave+ thermostat and its receiver
• Backlit LCD screen
• Can control electric heaters, boilers or magnetic valves 
• Fully compatible with other Z-Wave products
• Easy to use

Technical characteristics

• SRT321 thermostat
  • Module type: Z-Wave+ controller
  • Power supply: 2x AAA batteries (LR3)
  • Battery life: 2 years
  • Frequency: 868.42 MHz
  • Range: up to 30m in open air
  • Operating temperature: 0°C to 40°C
  • Temperature range: 5°C to 30°C
  • Precision: 0.5 °C
  • Protection rating: IP30
  • Dimensions: 86 x 86 x 36.25mm
• SSR303 receiver
  • Module type: Z-Wave+ receiver 
  • Power supply: 230VAC
  • Frequency: 868.42 MHz
  • Range: up to 30m in open air
  • Protection rating: IP30
  • Maximum load: 3A on 230VAC
  • Operating temperature: 0-40°C
  • Dimensions: 86 x 86 x 36.25mm